Installation Guide
A step-by-step overview of professional Paint Protection Film and Automotive Window Film installation.
Professional Steps
Installation should be performed by certified professionals for best results and warranty compliance.
- 01Step 01
Clean & Prep
Thoroughly decontaminate the paint — wash, clay, and iron-remove. Panels must be 100% free of dust and oils.
- Use pH-neutral prep
- Allow surfaces to dry completely
- Inspect under bright light for defects
- 02Step 02
Pattern & Cut
Use pre-cut patterns from a digital template, or hand-trim after installation. Allow overlap for edges.
- Verify fitment before spraying
- Keep cut line off painted edges when possible
- 03Step 03
Slip & Tack Solution
Spray slip solution on the adhesive side and tack solution on the panel. This gives working time for positioning.
- Slip: distilled water + small amount of dish soap
- Tack: cleaner slip solution ratio for initial grip
- 04Step 04
Apply & Squeegee
Position and squeegee out solution from center outward, using overlapping strokes to eliminate air and water pockets.
- Use soft felt-edge squeegee
- Use heat gun on complex curves
- 05Step 05
Cure
Allow 48–72 hours minimum before washing. Full cure takes 3–7 days depending on temperature and humidity.
- Avoid car washes during cure
- Park indoors if possible
- Do not polish during cure period
Do's and Don'ts
Do
- Work in a clean, dust-free environment (indoor shop preferred)
- Use correct slip/tack solution ratios
- Apply even pressure with quality squeegees
- Allow full cure before the first wash
- Store film rolls at recommended temperature
Don't
- Don't install in direct sun or high wind
- Don't use household glass cleaners during cure
- Don't wash the vehicle for 48–72 hours after Paint Protection Film install
- Don't roll windows down during the 3–7 day cure period
- Don't use ammonia-based cleaners on window film
Coverage Options
Standard Protection
- Partial hood
- Partial fenders
- Full bumper
- Headlights
- Mirrors
- Door edges
- Handle inserts
Extended Protection
- Full hood
- Full fenders
- Full bumper
- Headlights
- Mirrors
- Door edges
- Handle inserts
Full Wrap Protection
- Whole vehicle, bumper to bumper
- Chrome and painted grill
- All panels
- Rocker panels
- Rear bumper
- A/B/C pillars
Installation Questions
We strongly recommend professional installation. DIY installs rarely achieve the fit, seal, and longevity of trained installers — and warranties are tied to proper installation.